Invacare Softform Active 2 Rx Gebrauchsanweisung Seite 6

Invacare® Softform Active® 2 Rx
4.2 Installing the System
1. Hang the control unit by means of the two built in hangers
A at the foot end of the bed or place it on a horizontal
surface. (Placing the control unit on the floor will not
affect the performance, but may expose it to accidental
damage.)
2. Connect the CPR hose E to air outlets on the mattress and
control unit B, ensuring that the hose is not kinked or
twisted. Allow space for bed rails to drop freely.
3. Connect the mains power cable to the power supply
socket C of the control unit and a suitable outlet.
4. Switch on mains power of the outlet if present.
5. Move the mechanical switch D on the left side of the
control unit to the On position. A faint single beep sounds
and the system in-cycle light flashes while the system
powers up.
Refer to 8.1 Identifying and Repairing Defects, 10 if the
indicator is not flashing.
5 Usage
5.1 Safety Information
WARNING!
Insufficient repositioning of the patient can lead to
tissue compression and potential injury formation.
To relieve pressure, it is very important for the
patients to reposition themselves, or to be
repositioned, on a regular basis.
— Before using the product, always consult a
qualified healthcare professional for clinical
judgement.
— Monitor the patient frequently.
6
CAUTION!
— Make sure that the printed side of the mattress
cover always faces upwards.
— Ensure that the distance between the surface of
the mattress and the top of the side rail is at
least 220 mm.
CAUTION!
Risk of damage to the mattress
If holes are present in the mattress cover, there is a
risk that liquids may ingress and contamination may
occur.
— Ensure that the mattress is not jammed or
damaged by sharp edges.
— Do not place hypodermic needles, venflons,
scalpels or other similarly sharp objects on or
under the mattress.
— Do not use electrically heated blankets directly
on or under the mattress.
— Ensure that all venflons are taped down
correctly with no sharp edges exposed.
— When using bridging boards or other patient
transfer aids, check for any sharp edges or burrs
before use. When using the mattress on a
profiling bed, ensure that the knee break is
used before the backrest.
— Attach medical equipment, including infusion
pumps and monitors, to appropriate bed
accessories.
— Avoid cigarette burns and pet claws puncturing
the mattress cover.
5.2 Control Unit Menu Display
Overview
Description
A Mute button
Function
The relevant audible / visible
indicator turns on when low
pressure, power failure or
alternate failure is recognized.
To mute the audible signal,
press the Mute button. The
visible indicator will flash until
the problem is solved. If the
problem indicated has not been
solved within ten minutes, the
indicator will sound again. Press
the Mute button to mute the
audible indication; the indicator
will not sound again. Refer to
chapter 8 Troubleshooting, 10.
1630000-F