Invacare Softform Active 2 Rx Gebrauchsanweisung Seite 5

3.5 Scope of Delivery
The following components are included within the scope of
delivery:
A Cardiopulmonary Resuscitation (CPR) Connector
B U-Shaped, non-castellated base layer
Alternating air cell insert
C
D Castellated foam insert
E Multi-stretch vapour permeable cover
F Toughened polyurethane-coated base
G Control Unit
H User Manual
Power lead (not shown)
4 Setup
4.1 Safety Information
WARNING!
Electrical shock hazard!
— Do not remove control unit shroud.
— Refer to qualified service personnel.
— Before performing any maintenance to the
control unit, disconnect the power lead from
the wall outlet.
— Do not insert items into any openings of the
control unit. Doing so may cause fire or electric
shock by shorting the internal components.
— The control unit must be kept away from all
heat sources and radiators during operation.
— Connect the equipment to a two or three
prongwall outlet using the five-meter power
lead provided with the product.
— Position the device in such a way that always
ensures access to the power switch and CPR
Connector.
5
WARNING!
If this equipment is modified, appropriate inspection
and testing must be conducted to ensure continued
safe use of the equipment.
— Do not modify this equipment without
authorization of the manufacturer.
WARNING!
Risk of entrapment!
Patient entrapment with the bed side rails may
cause injury or death. A thorough patient
assessment should be completed and monitored
and the equipment should be used as specified and
maintained to reduce the risk of entrapment.
Variations in bed side rail dimensions, and mattress
thickness, size and density could increase the risk of
entrapment.
— Mattress must fit bed frame and side rails to
prevent patient entrapment. Follow the bed
manufacturer's instructions.
— After any adjustments, repair or service and
before use, make sure all attaching hardware is
tightened securely. Side rails with dimensions
different from the original equipment supplied
or specified by the bed manufacturer may not
be interchangeable and may result in
entrapment or other injury.
WARNING!
Risk of damage to the mattress
This mattress is recommended to be installed on
medical bed frames with bed side rails or assist rails.
It is preferred that the rails to be in the raised
position whenever the patient is on the bed.
Healthcare professionals assigned to each case
should make the final decision as to whether side
assist rails are warranted after assessing patient risk
of entrapment.
Controls on the footboard may be obstructed by the
control unit on a few bed frames. It may be
necessary to relocate the control unit.
— Before placing the patient on the bed, check
that air hoses and power cord are clear of
moving bed components.
— Operate all bed frame motorized functions
through their full range of motion to be certain
that there is no pulling, interference or
pinching.
— Take care when positioning hoses and cables to
eliminate the risk of tripping hazards or
strangulation.
4 Setup
1630000-F