Invacare Softform Active 2 Rx Gebrauchsanweisung Seite 12

Invacare® Softform Active® 2 Rx
10.2 Electromagnetic Emission
Guidance and Manufacturer´s Declaration
This product is intended for use in the electromagnetic environment specified below. The customer or the user of this product
should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations / flicker
emissions IEC 61000-3-3
10.3 Electromagnetic Immunity
Guidance and Manufacturer´s Declaration
This product is intended for use in the electromagnetic environment specified below. The customer or the user of this product
should assure that it is used in such an environment.
Test / Compliance
Immunity test
Electrostatic ± 8 kV contact
discharge (ESD)
± 2 kV, ± 4 kV, ± 8 kV,
IEC 61000-4-2 ± 15 kV air
± 2 kV for power
supply lines; 100 kHz
Electrostatic
repetition frequency
transient / burst
± 1 kV for input /
IEC 61000-4-4
output lines; 100 kHz
repetition frequency
Surge ± 1 kV line to line
IEC 61000-4-5 ± 2 kV line t o earth
< 0% U
Voltage dips,
short at 45° steps
interruptions
0% U
and voltage
variations on 70% U
power supply
cycles
input lines
< 5% U
IEC 61000-4-11 cycles
Power
frequency
(50/60 Hz)
30 A/m
magnetic f ield
IEC 61000-4-8
12
Compliance
Group I
Class B
Class A
Complies
Electromagnetic environment – guidance
level
Floors should be wood, concrete or ceramic tile. If floors are covered w ith
synthetic material, the relative humidity should be at least 3 0 %.
Mains power quality should be that of a typical commercial or hospital
environment.
Mains power quality should be that of a typical commercial or hospital
environment.
for 0.5 cycle
T
Mains power quality should be that of a typical commercial or hospital
for 1 cycles environment. If the user of this product requires continued operation d uring
T
power mains interruptions, it is recommended that the product i s powered from
for 25 / 30
T
an un-interruptible power supply or a battery.
U is the a. c. mains voltage prior t o application of the test level.
T
for 250 / 300
T
Power frequency magnetic fields should be at levels characteristic o f a typical
location in a typical commercial or hospital environment.
Electromagnetic environment - guidance
This product uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
This product is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
that supplies buildings used for domestic
purposes.
1630000-F