Santec Dome; Connection; Configuration - Eneo EKR-KB1 Betriebsanleitung

6.15 Santec Do me

6.15.1 Connection

6.15.1.1 Cable
6.15.1.2 Setting up the dome
The dome number and protocol should be correctly configured. The baud rate can be selected between: 2400
(default), 4800, 9600 baud. Consult the dome manual.
6.15.1.3 Setting up the keyboard
While configuring the keyboard, the submenu
following settings:




6.15.2 Configurati on
Dome configuration is mostly carried out using the On Screen Menu.
For all dome setup operations the keyboard should be enabled for TELEMETRY CONFIGURATION (menu

6.15.2.1 OSM Configu ration
Directly connect the dome to the keyboard as shown in the diagram and a monitor to the dome video output.

start dome configuration.
The dome shows the on screen menu; the keyboard display shows the mode change:




end of configuration.
The ESC key required by dome configuration procedure is replaced by the
Important note! When exiting dome configuration it is necessary to press
operation.

Joystick : cursor movement within the menus

: replaces the CTRL key.

: replaces the ESC key.
White RS485A
Yellow RS485B

The baud rate should correspond to the one chosen for the
dome.
).
Page 97
TX +
TX -

key.


t o return the keyboard to normal
, should have the
MNNCEKRKB1_0439