Controlling The Multiplexer Using A Video Device; Selecting A Monitor Connected To The Video Matrix; Selecting A Monitor Connected To The Multiplexer - Eneo EKR-KB1 Betriebsanleitung

5.15 Controllin g the multiplexer using a video device
The multiplexer can be controlled using a new
generation video device (EKR-8/4, EKR-16/4).
In order to control a multiplexer in this way, the
MACRO protocol must be used.
In this case control may refer equally to the video matrix or the multiplexer. Therefore the choice of active
monitor should be made differently in each case.

5.15.1 Selecting a monitor connected to the video matrix


Press , followed by the monitor number and if correct confirm with
After selecting a monitor the display will show the word
Only monitors that have been defined as "enabled" in the
requested.

5.15.2 Selecting a monitor connected to the multiplexer

To each multiplexer corresponds a single main monitor. To use the optional spot monitor see the respective
users' manual..
If the multiplexer is identified by an address (Eneo multiplexer for example), press
multiplexer address and if correct confirm with
If the multiplexer is not identified by an address (a SP16C mux for example) press
correct confirm with
After selecting a multiplexer the display will show the word
Only multiplexers that have been defined as "enabled" in the
requested.

.
, followed by the monitor number.



.
, followed by the multiplexer number.


Page 48
MUX
AUX
V

.


MNNCEKRKB1_0439
menu can be
, followed by the
and if
menu can be