Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.2.4.2 Requesting th e views
Press a key from
5.2.4.3 Erasing the c ustomised views
Press keys
The default settings for the views can be used to recall cameras 1 to 9 directly without changing the active
monitor and without making scans. The
5.2.5 Receivers a ssociated with the cameras
To each camera is associated a telemetry receiver.
It is possible for one receiver to be present for each camera and this receiver is assigned permanently at the
system installation stage. When the camera-receiver association has been defined it should never be changed
unless there are changes to the system itself.
The installation procedure normally expects the assignment of a receiver number corresponding to that of the
video input (for example, camera number 10 is controlled by receiver number 10), but the assignment may be
more flexible.
Every time a camera has been requested and following this selection a new receiver number is requested, this
receiver number will be "remembered" by the keyboard. If requesting a different receiver number from the pre-
assigned
number
For example:
to
to request the corresponding view.
simultaneously.
is
not
to
be
allowed,
recalls camera 10.
we
advise
Camera 1 has been requested. The display
shows that the receiver currently associated
with this camera is number 1.
If the operator is authorised to do so, he can
assign another receiver number to the camera;
if not the display shows an error message.
Camera 2 has been requested, and the display
shows that it is currently associated with
receiver 2.
Following the new request for camera 1 the last
receiver associated with camera 1 is shown.
Page 28
disabling
the
setup
MNNCEKRKB1_0439
menu
option:
Werbung
Kapitel
Inhaltsverzeichnis
