Auto Scan Control; Timers - Eneo EKR-KB1 Betriebsanleitung

6.5.10 Auto scan c ontrol
6.5.10.1 Control
Normal


6.5.10.2 Preset positio ns

 

 
 

 
6.5.10.3 Alarm positio ns

 

 
 

 

6.5.11 Timers

 
00: continuous; 01÷23: from 5 to 115 minuts (step 5 minutes); 24÷44: from 2 to 12 ore (step 30 minuts); 45÷56:
from 13 to 24 hours (step 1 hour)
 
The first X cypher is the number of Aux contact (1÷8); the following ones the time:
00: continuous; 01÷05: from 1 to 5 minuts (step 1 minute); 06÷15: from 10 to 55 minuts (step 5 minuts); 16÷27:
from 1 to 12 hours (step 1 hour); 28: 24 hours
 
 
 
 
 
Alarm
start

:
stop

:
: add all preset positions
( 1÷99): add a single preset position
: remove all preset positions
( 1÷99): remove a single preset position
( 1÷99): dwell time in seconds after reaching a position
: request a maximum speed movement
( 1÷8): set a reduced speed factor
: add all alarm positions
( 1÷99): add a single alarm position
: remove all alarm positions
( 1÷99): remove a single alarm position
( 1÷99): dwell time in seconds after reaching a position
: request a maximum speed movement
( 1÷8): set a reduced speed factor
( 00÷56): autopan stop
( 1÷8, 00÷28): aux contacts reset.
( 00÷28): wiper stop*
( 00÷28): washer stop*
( 00÷28): light stop*
( 00÷28): heater stop*
( 00÷28): fan stop*
start
:
stop
:
Page 66 MNNCEKRKB1_0439