Pelco Dome; Reference Material And Documents; Connection; Setup - Eneo EKR-KB1 Betriebsanleitung

6.13 Pelco Dom e
6.13.1 Reference m aterial and documents
Dome Spectra II 3.31
Pelco Protocol Manual, "D" Protocol, March 2, 1999

6.13.2 Connection

6.13.2.1 Cable
6.13.2.2 Dome setting s
Dome ID-number must be set according to the respective installation manual.
Protocol must be set as Type 'D'.
6.13.2.3 Keyboard set tings
During Keyboard setup, submenu





6.13.3 Setup

The dome can be set up by pressing a combination of keys or by inserting a special code.
For all setup operations the keyboard must be enabled to perform the receiver setup (menu

6.13.4 Preset, sca n, home

(1÷32): store the present position as preset position number X


(1÷32): movement towards previously stored position X

: movement towards the Home position, corresponding to preset position 1

: movement towards pan position 0
White
Yellow

Baudrate is fixed (2400 baud).
(1÷32): erase previously stored preset position number X
RS485A RX+
RS485B RX-
).
Page 91
must be suitably set:
MNNCEKRKB1_0439