Dedicated Functions - Eneo EKR-KB1 Betriebsanleitung

5.12.2.4 Operational t est
If the keyboard is connected directly with the multiplexer set up in this way using the cable as indicated above, it
should be possible to switch the input videos immediately:

• press

• press
Each command sent by the keyboard corresponds to the lighting up of an LED on the local multiplexer
keyboard.
Warning! If the number of the multiplexer unit does not coincide with the commands sent from the
keyboard, they will be ignored.
5.12.3 Dedicated f unctions
As well as the normal procedure for selecting input videos, the Eneo multiplexer is equipped with numerous
other functions that can be activated by pressing key combinations, and that correspond to the keys present on
its local keypad.

The key is used to change the number of the unit responding to the command.
Only some of the functions given below are available for both models of the multiplexer. Refer to the multiplexer
manual for further information.

live record,
 
select,

menu

spot monitor output,

"2nd" key,
 
4x4,
 
2+8,
to select multiplexer unit 1

, , to select the input videos.
 
vcr,
double select
 
auto,
 
pip1,

pip2,
set.
spot monitor

full,

2x2, 3x3

zoom, 3+4
Page 43
freeze
MNNCEKRKB1_0439