Operational T Est - Eneo EKR-KB1 Betriebsanleitung

5.11.2.2 Matrix setting s
Inside the matrix, both jumpers JP1 and JP2 should be set up for RS232 type communication, as shown in the
drawing.
Dip switch SW1 is used to select the baud rate:
Baudrate
9600 baud
1200 baud
Refer to the respective manual for further information.
5.11.2.3 Keyboard set tings
While the keyboard is being set up, the
follows:




Even in the presence of more than one keyboard connected to the matrix, the identification number of each
keyboard is of no importance.

5.11.2.4 Operational t est

If the keyboard is connected directly with the switcher set up in this way using the telephone cable supplied, it
should be possible to switch the input videos immediately:

• press

• press
dip 3 dip 4
ON ON
OFF ON

Control of a SW164OSM matrix.
to select monitor 1

, , to select the cameras.
Page 40
submenu should be set as
MNNCEKRKB1_0439