6.10.6 Patrol
The three patrol sequences are set during OSM setup.
( 1÷3): selects the active patrol sequence and starts immediately, without pressing the
key. Warning! If the patrol function is active the dome will not respond to other commands until it has been
stopped by
( 1÷3): selects the active patrol sequence and waits for the
the selected sequence
: starts the active patrol sequence. Warning! If the patrol function is active the dome will not respond to
other commands until it has been stopped by
: stops the patrol.
6.10.7 Other comm ands and special codes
horizontal rotation through 180 degrees (autoflip)
Enabling automatic autoflip:
Information on video:
no information shown on video
"Area title":
"Event display mode":
: autofocus on
enable;
information on the camera,
shown,
hidden
enabled,
disable
disabled
Page 83
key to be pressed to activate
service information,
MNNCEKRKB1_0439