Patrol; Relays; Other Functions - Eneo EKR-KB1 Betriebsanleitung

6.20.5 Patrol

The patrol sequence consists of a series of preset positions that are shown one after the other, with a fixed
dwell time when each position is reached. The standard patrol allows a maximum of 14 positions.

start patrol

p atrol setup
When the keys are pressed the display shows a modify patrol menu.
The patrol is only actually modified when the setup is transmitted to the receiver:





















6.20.6 Relays

When the activation/deactivation of a relay is requested, the display will always show the message "4 relays
available". Their number may actually be different, depending on the receiver model that is connected, as
described in the table "Available functions for each receiver model".

activate/deactivate relays (toggle); when the key is pressed the display will ask for the relay number.
6.20.7 Other funct ions

washer on

wiper on
Select "Preset positions" to define the patrol sequence.
Use the joystick to select each position and define whether is active
(joystick to the right) or not (joystick to the left).

to end.
Select "Dwell time" to define the dwell time when each position is
reached. The time is the same for all positions.
Insert a time between 1 and 60 seconds.
Select "Transmit data" to transmit the patrol setup to the receiver.
Page 111 MNNCEKRKB1_0439