Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Communi cation lines and connections
3.1 Video and telemetry lines
The EKR-KB1 keyboard can be used to control a wide range of products, for both video control (video matrixes
and multiplexers) and telemetry control (receivers and domes). It is therefore necessary to define the system
structure at the keyboard level to achieve efficient communication between the connected devices.
"Video line" means the communication channel intended to control the video devices; "telemetry lines" means
the two channels available for telemetry control.
We advise starting with the setup of the single "video line" and after that passing to the setup of the "telemetry
lines".
3.2 RS485 an d system types
The RS485 communication channels are 2-wire lines whose maximum length from end to end is 1200m.
The termination of the RS483 lines prevents signal reflection along the cable and should be inserted in each of
the devices that forms the end of a connection.
Systems can be of different types, therefore the way of terminating the lines will also be different.
In the diagrams shown below, the devices requiring termination are indicated by the # symbol.
Setup
Star
Single lines
Backbone
Line with stub
Description
/
For each connection between two
devices there should be a separate
communication line, with a maximum
length of 1200m.
All devices should be terminated, since
each device is connected to an end of
the line
A
single
line
is
transmitters can be placed in any
position along it. The two ends of the
line (keyboard K and receiver R3 in the
example) are terminated; the other
devices
(R1
and
terminated. The maximum length of the
line is 1200m.
The
specifications
standard allow at least 32 devices to be
connected along the same line.
A certain number of stubs can be
shunted in parallel to the normal RS485
line, for connection to other devices.
Since the stubs are not at the ends of
the line, they should not be terminated
and they should be very short in length
(of the order of a couple of metres).
The
specifications
standard allow at least 32 devices to be
connected along the same line.
Example
used,
and
the
R2)
are
not
for
the
RS485
for
the
RS485
Page 11
MNNCEKRKB1_0439
Werbung
Kapitel
Inhaltsverzeichnis
