Notes Concerning Assigning The Receivers; Warning Message; Accepting The Request For Monitors; Default Setting - Eneo EKR-KB1 Betriebsanleitung

















4.5.5 Notes conc erning assigning the receivers
After the receivers have been assigned in the menu, the
enabled see § 4.5 - Accepting requests for cameras and assigning receivers, page 16
4.5.6 Warning m essage
If a disabled camera is requested, the display will show a message warning the operator that the request is not
authorised:




4.6 Accepting the request for monitors

Accepting the monitors is used to prevent an unauthorised operator from operating monitors that are not within
his duties.
4.6.1 Default sett ing
The default setting allows control of all monitors, erasing any previously defined setting.
4.6.2 Modifying t he list
The procedure for accepting and disabling the monitors is the same as that just described for the cameras (see
§ 4.5 - Accepting requests for cameras and assigning receivers, page 16).
Usually 99 monitors can be selected from the keyboard.
Normally camera with pan & tilt is assigned a receiver/dome with the
same number (camera 1, receiver 1, camera 2, receiver 2, etc.)
Under particular circumstances
systems for example) it may be necessary to assign a receiver
with a different number from that of the camera.
In the example given receiver 12 is to be assigned to camera 3,
and the receiver should be controlled on telemetry line B.
Scroll the list to find the camera to have a new setting and press

to proceed with the change.
The column shows a cursor: it is expecting insertion of the

receiver/dome number

to assign receiver 12.
After inserting the receiver number, if the keyboard is set up to
control two different telemetry protocols the menu will ask on
which line (A or B) the receiver is connected.

Press to assign line A,
After completing modification, pressing
previous menu and then again on up to the main menu.
The icon of the 1-10 set has now been changed to
only some of the cameras in the group are now accepted.

key will be automatically disabled (if it is to be re-
Page 19
(while installing
assigned to the camera.

for line B.

will return to the
MNNCEKRKB1_0439
composit
Press
to show that
