Eneo Fastrax Ii Dome; Material And Reference Documents; Connection; Configuration - Eneo EKR-KB1 Betriebsanleitung

6.7 Eneo Fas trax II Dome
6.7.1 Material an d reference documents
Dome Eneo Fastrax II EDC-141
Dome Eneo Fastrax II EDC-161
Dome Eneo Fastrax II EDC-141E
Dome Eneo Fastrax II EDC-142E
Dome Eneo Fastrax II EDC-143E
Fastrax II Protocol and Examples

6.7.2 Connection

6.7.2.1 Cable
6.7.2.2 Setting up the dome
The dome number should be configured correctly. The protocol should be set as FASTRAX II. The baud rate
can be selected between: 2400 (default), 4800, 9600 baud. Consult the dome manual.
6.7.2.3 Setting up the keyboard
While configuring the keyboard, the submenu
following settings:




6.7.3 Configurati on
Dome configuration is mostly carried out using the On Screen Menu.
For all dome setup operations the keyboard should be enabled for TELEMETRY CONFIGURATION (menu

6.7.3.1 OSM Configu ration
Directly connect the dome to the keyboard as shown in the diagram and a monitor to the dome video output.

start dome configuration.
The dome shows the on screen menu; the keyboard display shows the mode change:




end of configuration.
White
RS485A
Yellow RS485B

The baud rate should correspond to the one chosen for the
dome.
).
Page 73
TX +
TX -
, should have the
MNNCEKRKB1_0439