JMA VOLGA BIT Bedienungsanleitung Seite 13

1.- INTRODUCTION AND OVERVIEW
1.1 OVERVIEW
1.2 TRANSPORT AND PACKAGING
1.3 ID LABEL
2.- SAFETY MEASURES
2.1 REGULATIONS
2.2 SAFETY DEVICES
2.2.1 USER PROTECTION
2.2.2 PERSONAL PROTECTION EQUIPMENT
2.2.3 SAFETY SIGNS AND SYMBOLS
2.2.4 GENERAL SAFETY INSTRUCTIONS
2.3 RESIDUAL RISKS
3.- INSTALLATION AND PREPARATION OF THE MACHINE
3.1 ENVIRONMENTAL CONDITIONS IN THE WORKSHOP
3.2 CHARACTERISTICS OF THE LOCATION FOR INSTALLATION
3.3 PREPARATION OF THE MACHINE
4.- MACHINE FEATURES
4.1 ACCESSORIES
4.2 ELECTRICAL CIRCUIT
4.3 TECHNICAL DATA
4.4 NOMENCLATURE OF THE KEY
4.5 MAIN ELEMENTS OF THE MACHINE
4.6 COMPONENTS AND FUNCTIONAL PARTS
4.6.1 CLAMPS
4.6.2 ROTATION LOCK OF THE RIGHT-HAND SIDE CLAMP
4.6.3 COUNTERPOINTS (USE MODE)
4.6.4 MAXIMUM LENGTH OF KEY
4.6.5 PROBE SPRING
4.6.6 LOCKAGE OF THE X AXIS
4.6.7 Y AXIS LOCKING
4.6.8 CLAMP CARRIAGE FOR VERTICAL CUTS (OPTIONAL)
5.- OPERATION AND FUNCTION
5.1 ADJUSTMENTS
5.1.1 SIDE ADJUSTMENT
5.1.2 CUTTING DEPTH ADJUSTMENT
5.1.3 LATERAL STOP ADJUSTMENT
5.2 ENCRYPTION
5.2.1 ENCRYPTION OF THE MORTISE KEYS
5.2.2 ENCRYPTION OF FRONTAL KEYS
5.2.3 NCRYPTION OF VERTICAL CUTS
6.- MAINTENANCE
6.1 REPLACEMENT OF THE CUTTER
6.2 REPLACING THE PROBE
6.3 BRUSH REPLACEMENT
6.4 REPLACEMENT OF THE BELT
6.5 MOTOR REPLACEMENT
6.6 REPLACING THE FUSES
6.7 REPLACING THE LIGHTING LEDS
6.8 REPLACEMENT OF THE CONNECTION PLATE
7.- WASTE DISPOSAL
7.1 SWARF
7.2 PACKAGING
7.3 MACHINE
8.- ASSEMBLY DRAWING