Slide The Base Jaws Or Clamping Jaws On The Body - Rohm RVM Originalbetriebsanleitung

7 | Operation
7.4

Slide the base jaws or clamping jaws on the body

Procedure:
1. Loosen the clamping screw in the clampable base jaw by two to three
turns.
2. Slide the clampable base jaw on the body into the desired position.
NOTICE:
The clampable base jaw can be moved steplessly.
3. Screw the clamping screw back in.
NOTICE:
The clamping screw must be tightened to the specified tightening
torque of 140 Nm.
80 / 88 RVM DE-EN