Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.2
Improper Use
If the 5-axle clamp is operated for a purpose other than the intended use as
specified in this Operating manual, this is deemed to be improper use.
Any utilisation beyond the scope of the "intended use" poses risks and is
not approved by RÖHM.
Improper use refers to the following:
▪ Clamping or release while the machine spindle is running or during ma-
chining.
▪ Use of the 5-axle clamp with missing or damaged components.
▪ Clamping of workpieces with an incorrect clamping jaw set.
▪ Use of defective jaws (e.g. cracks in the jaws).
▪ Operation without a workpiece, or with the workpiece insufficiently
clamped.
▪ Clamping of elastic workpieces and insufficient clamping force.
▪ One-sided clamping of the workpiece.
▪ Internal clamping of workpieces.
▪ Clamping with external drives or applying an actuating force exceeding
the max. torque.
▪ Use of the 5-axle clamp in potentially explosive atmospheres.
▪ Cleaning with compressed air.
▪ Direct pointing of compressed air or coolant spray at guide gap or lub-
ricating nipple;
▪ Operation with insufficient maintenance.
▪ Using non-OEM parts as replacement parts.
▪ Use of the 5-axle clamp for suspending loads.
▪ Operation outside of the defined operating parameters.
▪ Operation at a speed of more than 20 rpm.
▪ Operation with modifications not approved by the manufacturer.
▪ Mobile use, e.g. in vehicles.
▪ Private use.
▪ Assembly of the 5-axle clamp and individual parts with incorrect tight-
ening torque.
RVM DE-EN
Safety | 2
EN
57 / 88
Werbung
