Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.3
Check the screw-in depth of the spindle
Procedure:
1
1 Base jaw, clampable
2 Threaded sleeve
3 O-ring
1. Place the movable base jaw with spindle against the clampable base
jaw with threaded sleeve.
2. Using a mounting wrench (consisting of reversible ratchet and socket
wrench insert SW12), screw the spindle into the threaded sleeve until
the O-ring is no longer visible.
NOTICE:
The O-ring must be inserted at the spindle.
NOTICE:
The movable base jaw is pulled against the clampable base jaw.
RVM DE-EN
2
NOTICE
Ø Check the screw-in depth of the spindle before each clamping.
Ø The O-ring must no longer be visible.
3
4
4 Spindle
5 Base jaw, movable
- -
Operation | 7
EN
5
79 / 88
Werbung
