Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 | Safety
2
Safety
Safety instructions and safety equipment serve to prevent accidents and
damage when working on the 5-axle clamp. The safety information contains
warnings and basic safety instructions. In addition to the safety instructions
in this chapter, the following chapters contain action-related warnings.
Maximum protection of personnel and the environment from dangers and
trouble-free operation is only possible when all safety instructions and
warnings in this operating manual are observed.
2.1
Intended Use
The 5-axle clamp is used to clamp regularly and irregularly shaped work-
pieces.
▪ The 5-axle clamp may be installed in all machining centres and pro-
cessing machines for cutting and non-cutting processes.
▪ The 5-axle clamp can be operated stationary or at a low speed of up to
20 rpm. A clocking or swivelling movement is permissible.
▪ The 5-axle clamp can be installed horizontally on the side as well as
vertically.
▪ The clamping force may only be generated manually (clockwise rota-
tion).
▪ In the case of special workpiece geometries, corresponding jaws must
be used.
▪ The workpieces to be clamped must have a sufficient strength for the
clamping force and minimum compressibility.
▪ Other materials may only be used with the agreement of RÖHM.
▪ The 5-axle clamp is only suitable for external clamping of workpieces.
▪ The 5-axle clamp is intended for commercial use only.
56 / 88
RVM DE-EN
Werbung
