Rohm RVM Originalbetriebsanleitung Seite 75

NOTICE:
The 5-axle clamp must be flat over the entire support surface.
NOTICE:
The clamping claws (2 on each side) must be attached to the bar at the
body at the height of the clamping area.
5.1.3 Attachment with pins for zero point clamping system
Pre-conditions:
▪ The support surface, slots, pins for zero point clamping system, bores
and threaded holes on the 5-axle clamp are cleaned
Procedure:
1
1 Body (L=345 mm)
1. Fasten the pins for the zero point clamping system to the body with
cylinder screws.
NOTICE:
For bodies with L=345 mm in grid 200
NOTICE:
The cylinder screws must be inserted and tightened with the respective
tightening torque.
2. Align the 5-axle clamp with the pins for the zero point clamping system
and place it on the mounting surface.
NOTICE:
The 5-axle clamp must be flat over the entire support surface.
RVM DE-EN
2
2 Pins for zero point clamping
system
Assembly | 5
EN
75 / 88