Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.5
Personal Protective Equipment and Personnel Qualification
When working on and with the 5-axle clamp, personal protective equipment
must be worn. The owner is responsible for providing personal protective
equipment.
▪ Personal protective equipment must be in perfect condition when carry-
ing out work. Defective protective equipment is to be replaced immedi-
ately.
▪ Observe information on personal protective equipment posted in the
working area.
Wear protective gloves
Wear safety goggles
Wear safety shoes
Wear protective clothing
Work on and with the 5-axle clamp may only be carried out by qualified op-
erating and specialist personnel (see Qualification of Operating and Special-
ist Personnel).
2.6
General Dangers
When using the device there is a special potential of residual risks
▪ during assembly and set-up work,
▪ during operation and
▪ during maintenance and service work.
This potential risk cannot be completely eliminated considering the func-
tional availability of the operating manual. Therefore, all individual regula-
tions of this Operating manual are to be observed.
2.6.1
Dangers due to hot surfaces
Description of the hazard:
The 5-axle clamp may heat up during operation. There is a risk of burning in
case of contact with the 5-axle clamp.
Avoiding the hazard:
Keep away from the 5-axle clamp immediately after it was in operation and
let it cool down before carrying out any work.
RVM DE-EN
Safety | 2
EN
59 / 88
Werbung
