Rohm RVM Originalbetriebsanleitung Seite 74

5 | Assembly
2. Attach the 5-axle clamp to the mounting surface with cylinder screws
and T-slot nuts.
NOTICE:
The cylinder screws must be inserted and tightened with the respective
tightening torque.
NOTICE:
The 5-axle clamp must be flat over the entire support surface.
5.1.2 Attachment with clamping claws
Pre-conditions:
▪ The support surface, slots, T-slot nut, fitting slot nuts, clamping claws,
bar at body, bores and threaded holes on the 5-axle clamp are clean
Procedure:
1
1 Clamping claw
2 Cylinder screw
3 T-slot nut
1. Align the 5-axle clamp with the fitting slot nuts and place it on the
mounting surface.
2. Attach the 5-axle clamp to the mounting surface with the clamping
claws, cylinder screws and T-slot nuts.
NOTICE:
The cylinder screws must be inserted and tightened with the respective
tightening torque.
74 / 88
2 3 4 5
4 Body
5 Bar at body
6 Fitting slot nut
6
RVM DE-EN