Assembly; Mounting The 5-Axle Clamp On The Mounting Surface; Attachment With Cylinder Head Screws And T-Slot Nuts - Rohm RVM Originalbetriebsanleitung

5

Assembly

5.1

Mounting the 5-axle clamp on the mounting surface

Pre-conditions:
▪ Personnel qualification: Skilled worker
▪ Wear personal protective equipment
▪ The machine is switched off and protected against being switched on
again
▪ Mounting surface is cleaned.
5.1.1

Attachment with cylinder head screws and T-slot nuts

Pre-conditions:
▪ The support surface, slots, T-slot nut, fitting slot nuts, bores and
threaded holes on the 5-axle clamp are clean
Procedure:
1
1 Fitting slot nut
2 T-slot nut
1. Align the 5-axle clamp with the fitting slot nuts and place it on the
mounting surface.
RVM DE-EN
2 3
3 Cylinder screw
4 Body
Assembly | 5
4
EN
73 / 88