Rohm RVM Originalbetriebsanleitung Seite 78

7 | Operation
7.2.2 Mounting of clamping jaws
Pre-conditions:
▪ The contact surfaces on the clamping jaw are clean
Procedure:
1 Clamping jaw
2 Base jaw
3 Key
The adjustment dimension on the spring-loaded pressure pieces must
not be changed.
1. Check the adjustment dimension.
NOTICE:
If necessary, correct the adjustment dimension via the spring-loaded
pressure pieces.
2. Place the clamping jaws diagonally on the base jaws using the slot for
the key and press firmly until they engage.
NOTICE:
Depending on the type of clamping jaws, they can be mounted rotated
by 180°.
This way, the clamping range can be extended.
Ø The clamping jaws are mounted.
78 / 88
1
5
2
4
4 Spring-loaded pressure piece
5 Adjustment dimension
- -
3 4
RVM DE-EN