Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.1
Transporting the 5-axle clamp
1
1 Body
2 Base jaw, clampable
3 Clamping screw
Procedure:
1. Position the two base jaws in the middle of the body and with a dis-
tance of approx. 35 mm.
2. The clamping screw SW12 must be tightened to the specified tighten-
ing torque of 140 Nm.
3. Place a suitable lifting strap around the spindle.
4. Lift the 5-axle clamp and transport it in a manually-driven manner. The
5-axle clamp must not wobble.
NOTICE:
When lifting, transporting and putting down the 5-axle clamp, ensure
that no collisions occur with other parts of the machine etc.
RVM DE-EN
2
3
The 5-axle clamp must not be transported if the clamping screw
is released.
4 Spindle
5 Base jaw, movable
- -
NOTICE
Transport | 4
4
5
71 / 88
EN
Werbung
