Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Configurating the CIM 25X
Before the SMS functions of the CIM 25X can be
used, the CIM 25X must be configured using the
SMS configuration commands in this section.
The commands are divided into four groups:
One group for basic configuration and three groups
for the type of connection to be established.
•
Commands for basic configuration (mandatory).
See section 2.1 Basic configuration.
•
Commands for configuration of the CIM 25X for
monitoring and control via SMS.
See section 2.2 Configuration for monitoring and
control via SMS.
2.1 Basic configuration
Command
INIT <access code>
ROAMING <ON | OFF>
6
•
Commands for configuration of the CIM 25X for a
GSM call-up connection.
See section 2.3 Configuration for GSM call-up
connection.
•
Commands for configuration of the CIM 25X for a
GPRS connection.
See section 2.4 Configuration for GPRS
connection.
First, carry out the basic configuration, as it is
common to all three types of connection and
required for any installation. Then, carry out the
configuration for the type of connection to be
established. The default setting will work in most
cases.
See also section 6. Overview of commands.
Description
The first time the CIM 25X is used, it has to be initialised with this
command.
The number of the mobile phone used for initialising the CIM 25X will
be added to the internal phone number list of the module. Access via
commands can now take place from this number or by using the
access code, which must consist of four digits between 0 and 9.
Before carrying on the configuration, wait until the CIM 25X has
acknowledged the change with this message:
INIT: <phone number> added to the phone number list
Access code: <access code>
If the CIM 25X has already been initialised, it will send this message:
INIT: Already initialised
Note:
When the command INIT has been carried out, settings can only be
changed from the phone number used for initialising the CIM 25X or
with the selected access code in front of the command.
After initialisation, the CIM 25X will use the default settings, and in
most cases, it will not be necessary to change them.
See section 6.1 Configuration commands for the CIM 25X.
However, please read the rest of this table, and check that the
default settings meet the requirements.
If the CIM 25X is to be re-initialised at a later time (for instance if you
have forgotten the access code), press the reset button on the
module for at least five seconds. This resets settings to the default
settings. The command INIT must be sent to the CIM 25X again. For
further information about hardware reset, see installation and
operating instructions for the CIM 2XX GSM module.
With this configuration command, it is possible to set whether the
CIM 25X is to accept roaming or not. The CIM 25X will acknowledge
the change with this message:
ROAMING: changed to <ON | OFF>
If roaming is set to OFF, this will apply to both GSM, SMS and GPRS
communication. If roaming is set to ON, this will apply to GSM and
SMS communication, whereas roaming for GPRS communication will
only be allowed if GPRSROAMING has also been set to ON.
Default setting: ON.
Werbung
