Grundfos CIM 25X SMS commands Montage- Und Betriebsanleitung Seite 87

2.2 Configuration for monitoring and control via SMS
Command
ACCESS <access option>
CODE <access code>
ADDNUMBER [phone number]
Description
Select the access option with this configuration command:
• LIST
Only numbers in the CIM 25X phone number list can send
configuration and control messages.
• CODE
The 4-digit access code must be used in front of all configuration
and control commands.
• BOTH
Both LIST (phone number list) and CODE (access code) can be
used for access control. Only one is required to get access.
• NONE
There is no access control. All commands can be sent from a
mobile phone without access control.
Before carrying on the configuration, wait until the CIM 25X has
acknowledged the change with this message:
ACCESS: changed to <access option>
Default setting: BOTH.
With this configuration command, it is possible to change the 4-digit
access code.
Before carrying on the configuration, wait until the CIM 25X has
acknowledged the change with this message:
CODE: changed to <access code>
With this configuration command, it is possible to add a number to
the CIM 25X phone number list. The number must be of international
format with '+' followed by the country code and the local number. In
the case of local numbers, '+' and the country code are not required.
Up to four numbers can be stored.
When a number has been added, the CIM 25X will acknowledge the
change with this message:
ADDNUMBER: <phone number> added to the phone number
list
The message will be sent to both the sender of the command and to
the phone number which has been added. If the parameter is
omitted, the phone number of the sender will be added.
When the CIM 25X has been initialised, only the number of the
mobile phone used for initialisation will be in the internal phone
number list of the module.
To see the phone number list, use the command LIST.
Note: If all phone numbers are deleted, make sure that the access
option is not LIST, as this would leave the CIM 25X unaccessible and
require a hardware reset (press reset button for five seconds)
followed by a reconfiguration. For further information about hardware
reset, see installation and operating instructions for the CIM 2XX
GSM module.
7