Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Status commands
It is possible to get information about the status of
the CIM 25X and the Grundfos product by means of
status commands. See table below. Apart from the
commands LIST, GPRSSETTINGS and SCADA, the
commands are not subject to access control (unless
STATUSPROTECT = ON) as they do not change
anything in the CIM 25X or the Grundfos product.
Command
GSMSETTINGS
LIST
SIGNALLEVEL
Description
With this status command, it is possible to see the configuration status of the
CIM 25X.
Example of reply:
[Installation name]
Configuration status:
Access control: CODE
Heartbeat: At 12:00 Wed
Roaming: OFF
SMS alarm: ON
SMS warning: ON
SMS limit: ON
TIME: 2010 Mar 29 08:35
Status protection: OFF
With this status command, it is possible to see which numbers are in the CIM 25X
phone number list. The CIM 25X will send a message with all phone numbers.
Each number takes up a line.
Example of reply:
[Installation name]
LIST:
+4520509988
+4521190627
+4522814495
If there are no numbers in the phone number list, the CIM 25X will send this
message:
[Installation name]
LIST: Phone number list empty
Note: LIST is subject to access control if another access option than NONE has
been selected.
With this status command, it is possible to get information from the CIM 25X about
the detected signal strength of the GSM network:
(Not detected, 0 %, 25 %, 50 %, 75 %, 100 %)
Example of reply:
[Installation name]
GSM signal level:
Actual 100 %
Average 50 %
The actual value is the value read from the CIM 25X right now; the average value
is the average of the signal during the last hour.
Note: Not all network operators support this service.
15
Werbung
