Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Command
DELNUMBER
[phone number | ALL]
NAME <installation name>
8
Description
With this configuration command, it is possible to delete a number in
the CIM 25X phone number list.
If the number exists, it will be deleted, and the CIM 25X will
acknowledge the change with this message:
DELNUMBER: <phone number> deleted from the phone
number list
The message will be sent to both the sender of the command and to
the phone number which has been deleted.
If the parameter is omitted, the phone number of the sender will be
deleted.
If the parameter is ALL, all phone numbers will be deleted, and the
CIM 25X will send this message:
DELNUMBER: Phone number list empty
To see the phone number list, use the command LIST.
Note: If all phone numbers are deleted, make sure that the access
option is not LIST, as this would leave the CIM 25X unaccessible and
require a hardware reset (press reset button for five seconds)
followed by a reconfiguration. For further information about hardware
reset, see installation and operating instructions for the CIM 2XX
GSM module.
With this configuration command, it is possible to give the CIM 25X
an installation name of maximum 30 characters. The name will then
be put in front of all messages from the CIM 25X. If a name consists
of more than 30 characters, it will be shortened automatically.
The CIM 25X will acknowledge the change with this message:
<Installation name>
NAME: New installation name stored
The installation name can be deleted by storing an empty installation
name. The CIM 25X will send this message:
NAME: Installation name cleared
Default setting: Empty.
Werbung
