SOLIS VERTIVAC Bedienungsanleitung Seite 78

CLEA N I NG VACU UM CON TAINERS
■
1. The containers without the lids can be hand washed in warm, soapy water.
Attention: Do not immerse the lids of the containers into water and don't
put them into a dishwasher. The inner cap underside of the container
lid can be removed and washed. Clean the lids themselves only with a
damp cloth. Allow them to dry thoroughly and re-insert the cap on the
underside of the lid.
2. Allow all accessories to dry completely, before storage or use.
GB
3. We recommend, to keep the rubber seals elastic, to rub them from time to time
with a few drops of cooking oil.
STO RING T H E A P P LI AN C E
s
Note: Always store the appliance with the release mechanism unlocked
●
after using it. This means that the appliance must always complete the
programs it is running and the bag has to be removed from the unlocked
vacuum bay.
If the power plug is pulled before the appliance is unlocked resp. a pro-
gram is deactivated, the seals remain locked and might warp, impairing
the functionality of the appliance.
Store the appliance in a flat dark place, out of reach of children, at best in it's origi-
nal packaging. The vacuum sealer can be stored standing on the appliance base or,
to save space, on the side (upright or lengthways) (see
The latching mechanism must not be locked so that no pressure is put onto the
seals. The seals are consumable material and are not covered by warranty.
Fig. 21 Fig. 22
154
).
Fig. 21+ 22
P R OBLEM S A ND POSS I BLE C AUS ES
s
T HE APPLI A NCE DOESN' T W ORK
■
1. Check that the plug is plugged into the correct socket.
2. Check whether the power cable is damaged. If this is the case, bring the appli-
ance to Solis or a Solis approved service centre to get the cable replaced.
3. Check whether the socket is working by connecting another electrical device.
4. Check if the bag end is evenly inserted in the vacuum bay resp. vacuum chamber
all the way to the end stop, meaning approx. 4 cm deep.
5. Check, if you have pushed the start lever after making adjustments to activate
the functions.
6. Wait for at least 1 minute before using the appliance again.
7. If you perform too many welding processes in a row, you might trigger the
thermo safety feature of the sealing bar. In that case, the appliance has to cool
down before you can continue using it.
T HE APPLI A NCE IS NO T SEA LI NG A N EM PTY B AG
■
Make sure that the end of the bag is correctly placed in the vacuum bay, pushed
all the way in, meaning approx. 4 cm deep and also that the Manual Seal button
has been touched and the start lever has been pushed.
T HE AI R I S NOT CO MPLETELY SUCKED O UT OF THE BA G
■
1. To ensure that the bag is firmly sealed, the open end of the bag has to be com-
pletely inserted without wrinkles into the vacuum bay resp. vacuum chamber to
the end stop, meaning approx. 4 cm deep.
2. Check whether the bag has a hole in it. To do this, seal the bag with some air in
it and submerge it in water. If bubbles rise from it, it is leaking, use another bag.
3. Use bags and films from Solis exclusively!
4. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean the
inside of the bag end and make sure to insert the bag end absolutely evenly and
all the way to the end stop, meaning approx. 4 cm deep into the vacuum bay.
GB
155