Error Messages; Maintenance And Cleaning - HomeMatic HM-CC-TC Montageanleitung Und Bedienungsanleitung

10

Error messages

If wireless communication with a valve actuator or a taught-in
sensor malfunctions, the antenna symbol flashes on the display.
Additionally, the letters "S" and "V" provide information about the
device type concerned. You can determine the device concerned
more precisely using the special function "VST" or "WST".
If a "LowBat" or "Wireless communication problem" message
occurs, an audible signal is output every hour between 8:00 and
20:00 in addition to the symbols appearing on the display. The
type of audible signal output indicates which device's batteries
are low:
Signal
1 beep, short pause, 1 beep
2 beeps, short pause, 2 beeps
3 beeps, short pause, 3 beeps
4 beeps, short pause, 4 beeps
11

Maintenance and cleaning

This product does not require you to carry out any maintenance
other than replacing the batteries when necessary. Enlist the help
of an expert to carry out any maintenance or repairs. Clean the
product using a soft, lint-free cloth that is clean and dry. You may
dampen the cloth a little with lukewarm water in order to remove
more stubborn marks. Do not use any detergents containing
solvents, as they could corrode the plastic housing and label.
56
Transmitting device
Actuator 1 or D/W contact 1
Actuator 2 or D/W contact 2
Actuator 3 or D/W contact 3
Actuator 4 or D/W contact 4