Siemens SIPROTEC 5 Handbuch Seite 148

IEC 60870-5-104
4.3 Interoperabilität
<59> := Double command with time tag CP56Time 2a
<60> := Regulating step command with time tag CP56Time 2a
<61> := Set point command, normalized value with time tag CP56Time 2a
<62> := Set point command, scaled value with time tag CP56Time 2a
<63> := Set point command, short floating point value with time tag CP56Time 2a
<64> := Bitstring of 32 bit with time tag CP56Time 2a
System Information in Control Direction
(station-specific parameter, mark each Type ID X if it is only used in the standard direction, R if only used in
the reverse direction, and B if used in both directions)
<104> := Test command
<105> := Reset process command
<106> := Delay acquisition command
<107> := Test command with time tag CP56time2a
Parameter in Control Direction
(station-specific parameter, mark each Type ID X if it is only used in the standard direction, R if only used in
the reverse direction, and B if used in both directions)
<110> := Parameter of measured value, normalized value
<111> := Parameter of measured value, scaled value
<112> := Parameter of measured value, short floating point value
<113> := Parameter activation
Type Identifier and Cause of Transmission Assignments
(station-specific parameters)
Shaded boxes are not required.
Black boxes are not permitted in this companion standard
Blank: functions or ASDU not used.
Mark Type Identification/Cause of transmission combinations:
X if only used in the standard direction
R if only used in the reverse direction
B if used in both directions
148 SIPROTEC 5, Kommunikationsprotokolle, Handbuch
C53000-L1800-C055-2, Ausgabe 06.2016
C_DC_TA_1
C_RC_TA_1
C_SE_TA_1
C_SE_TB_1
C_SE_TC_1
C_BO_TA_1
C_SE_NB_1
C_RP_NA_1
C_CD_NA_1
C_TS_TA_1
P_ME_NA_1
P_ME_NB_1
P_ME_NC_1
P_AC_NA_1