Operate The Machine; Start The Machine - Cramer 82ZT107 Bedienungsanleitung

EN
4.1.6 SAFETY START INTERLOCK SYSTEM
The machine is equipped with a safety start interlock system consisting of the park brake switches, operator
presence switch, and deck blades ON and OFF switch.
The mower's safety start interlock system is also designed to protect the operator and others from accidental injury
due to unintentional traction drive system starting.
Check mower safety start interlock system daily, prior to operation. This system is an important mower safety feature.
It should be repaired immediately if it malfunctions. The machine incorporates a separate operator presence switch
which will stop the drive system and deck motors when the operator is not in place for any reason while the mower is
operating. This is a safety feature designed to prevent runaway or accidental entanglement.
The safety interlock system must not be disconnected or bypassed. Doing so could cause the machine to operate
unexpectedly, resulting in personal injury.
To inspect the system:
1. The operator must be on the seat when testing the operator presence switch.
2. Turn the key to start the machine.
3. Pull the steering control levers to the parking slots.
4. Pull up on the PTO switch to engage the motor.
5. Slowly raise off of the seat. The deck blade system should stop.
6. If the deck blade system fails to stop when the operator is off from the seat and if the cause cannot be
determined, contact your Cramer dealer immediately.
4.2

OPERATE THE MACHINE

4.2.1 START THE MACHINE

See figure 14
Clear the area of bystanders before operating the mower. If anyone enters the mowing area, stop immediately and
do not return to mowing until the bystanders leave the area.
1. Raise the mower deck to its highest position.
2. Insert the start key and turn to ON position.
3. Pull right and left steering control levers inward.
4. Pull up on deck PTO switch to start cutting blades for mowing.
Only engage blades when steering control levers are in the NEUTURAL position! NEVER engage blades when
moving!
5. Place steering control levers in forward (D) position and drive to desired mowing location.
Use caution when crossing over gravel paths or driveways. Before crossing, disengage the blades and raise the
cutting deck to the highest position to minimize the possibility of ricochet. Drive slowly to avoid loss of traction
and control.
Do not attempt to change the direction of operation while the mower is in motion. Always come to a complete
stop before changing the mower direction.
English
WARNING
NOTE
NOTE
NOTE
NOTE
8