Cramer 82ZT107 Bedienungsanleitung Seite 18

EN
Error Code
ML13
ML14
ML15
ML16
ML17
ML18
ML19
ML20
ML21
ML22
ML23
ML24
ML25
ML26
ML27
ML28
ML29
ML30
ML31
ML32
MR1
MR2
MR3
MR4
MR5
MR6
MR7
Description
Controller overtemperature
Software overcurrent
Hardware overcurrent
Speed controller error
Controller pre-charge error
Brake error
Operating sequence error
Angle sensor error
Relay error
Magnetic valve error
Battery compartment (PMU) com-
munication failure
Battery compartment (PMU) failure
CAN timeout error - left drive
CAN timeout error - right drive
CAN timeout error - left blade
CAN timeout error - central blade
CAN timeout error - right blade
Battery compartment flip cover error Check that the connector under the seat is connected prop-
Failed to verify blade signal
Software authentication error
Motor positioning error
Blade motor stalled
Motor low-speed protection
Motor overspeed protection
Motor Hall-sensor error
Controller phase loss
MOSFET open circuit error
English
Solution
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply
The load is too high. Restart the power supply.
The load is too high. Restart the power supply.
Check that the speed controller of handle is connected prop-
erly, and then restart the power supply.
Restart the power supply.
Restart the power supply.
Place the left and right handles in the park position, and the
blade start switch in the OFF position. Sit in the seat and try
again.
Restart the power supply.
Restart the power supply.
Check that the solenoid valve of motor is connected proper-
ly, and then restart the power supply.
Communication failure with battery compartment. Restart
the power supply.
Minor/major error in battery compartment. Perform a check
and restart the power supply.
Communication failure with the left drive controller. Restart
the power supply.
Communication failure with the right drive controller. Restart
the power supply.
Communication failure with the left blade controller. Restart
the power supply.
Communication failure with the central blade controller. Re-
start the power supply.
Communication failure with the right blade controller. Restart
the power supply.
erly, and then restart the power supply.
Check that the blade start switch is connected properly, and
then return the switch to its initial position.
Restart the power supply.
Restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
Restart the power supply.
Restart the power supply.
Check that the Hall-effect connector of blade controller is
properly connected, and then restart the power supply.
Check that motor cables of the drive controller are connec-
ted properly, and then restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
18