Torque Values; Battery Pack Maintenance; Battery Compartment Filter Maintenance; Service - Cramer 82ZT107 Bedienungsanleitung

EN
7.4

TORQUE VALUES

Particular attention must be given to tightening the drive wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade, which can cause serious damage or personal injury.
Torque values are given below:
Part
Wheel (lug) nuts
Blade spindle bolt
Lug nuts only -It is recommended that these be checked after the first 2 hours of operation, initially, every 100 hours
and following removal for repair or replacement.
7.5

BATTERY PACK MAINTENANCE

Your Cramer mower is powered by a battery pack which, when maintained properly, will provide years of useful life.
For proper care, adhere to the following instructions:
• Always charge batteries after each use.
• Whenever a battery pack is fully discharged and turned off, it is best to recharge the battery as soon as
possible. Over-discharge of the battery pack means the battery life will be shortened and the battery may become
permanently damaged. There is no need to fully charge; it will be beneficial even if you only charge the battery
pack for 5-10 minutes. It is best to recharge it within 24 hours.
• Keep grass, dirt and debris from collecting near battery terminals and in battery area.
• Charge batteries indoors in a well-ventilated and dry location away from sparks or flames. Never expose charger
to rain, vapor or liquid.
• Charge only lithium batteries provided by Cramer.
• Do not touch uninsulated portion of charger (terminal pins) or of output connector.
• Do not use with defective cords and wires. Replace defective cords and wires immediately.
• For long-term storage, please make sure the storage temperature is -20°C - 45°C within one month, and 0°C -
35°C between two and twelve months.
• The working environment of the battery pack is -20°C -55°C for discharge, and 0°C~55°C for charge.
7.6

BATTERY COMPARTMENT FILTER MAINTENANCE

Replace the battery compartment filter every 200 hours.
7.7

SERVICE

Wait for all movement to stop before adjusting, cleaning or repairing. Repairs or maintenance requiring power
should be performed by trained maintenance personnel only. Read and observe safety warnings in front of manual.
Repairs or maintenance requiring power should be performed by trained maintenance personnel only.
• Park the mower on level ground. Make sure that steering control levers are in the neutral position, and that the
PTO switch is in "OFF" position. Raise deck, rotate key to "OFF" position, remove key from switch and remove
the battery packs from the battery compartment under the seat.
• Any maintenance operation that requires the removal of safety covers must be performed by a trained service
technician.
• Use a stick or similar instrument to clean under the mower, making sure that no part of the body -- especially
arms and hands -- is under mower.
• Keep your machine clean and remove any deposits of trash and clippings.
English
WARNING
Ft-lbs.
89
66
IMPORTANT
IMPORTANT
22
Nm
120
90