Install The Mulch Plug; Install The Side Discharge Chute; Set The Blade Height; Install The Battery Pack - Cramer 2502486 Bedienungsanleitung

2. Remove the side discharge chute.
3. Open the rear discharge flap and hold it.
4. Hold the grass catcher by its handle and engage the hooks
on the rear flap rod.
5. Close the rear discharge flap.
3.4

INSTALL THE MULCH PLUG

Figure 4
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge flap.
3.5 INSTALL THE SIDE DISCHARGE
CHUTE
Figure 5
CAUTION
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge flap and hold it.
2. Line up the recesses of the side discharge chute below the
pivot.
3. Close the side discharge flap.
3.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6
1. Push the height adjustment button, move the height adjust
gear to a higher position to increase the blade height.
2. Push the height adjustment button, move the height adjust
gear to a lower position to decrease the blade height.
3.7

INSTALL THE BATTERY PACK

Figure 7
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery compartment flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
English (Original Instructions)
5
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery compartment flap.
NOTE
The engine starts only when you put in the safety key.
3.8

REMOVE THE BATTERY PACK

Figure 7
1. Remove the safety key.
2. Open the battery compartment flap.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

WARNING
Wear eye protection during operation.
4.1

START THE MACHINE

Figure 8
1. Put in the safety key and battery.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the
direction of the handle bar.
4. Release the start button to start the machine.
4.2

STOP THE MACHINE

Figure 8
1. Release the handle switch to stop the machine.
WARNING
Wait until the blade fully stops before you start the machine
again. Do not quickly turn the machine off and on or it will
damage the machine.
WARNING
Always remove the safety key and battery pack after you
complete the work.
4.3 OPERATE THE SELF-PROPEL
SYSTEM
Figure 8
1. Start the machine.
2. While you hold the bail switch, push the self-propel lever
in the direction of the handle bar.
3. Hold the bail switch and the self-propel lever at the same
time with your right hand.
EN