Cramer 82ZT107 Bedienungsanleitung Seite 16

EN
Error Code
TR26
TR27
TR28
TR29
TR30
TR31
TR32
TL1
TL2
TL3
TL4
TL5
TL6
TL7
TL8
TL9
TL10
TL11
TL12
TL13
TL14
TL15
TL16
TL17
TL18
TL19
Description
CAN timeout error - right drive
CAN timeout error - left blade
CAN timeout error - central blade
CAN timeout error - right blade
Battery compartment flip cover error Check that the connector under the seat is connected prop-
Operator presence switch verifica-
tion error
Software authentication error
Motor positioning error
Drive motor stalled
Motor lowspeed protection
Motor overspeed protection
Motor Hall-sensor error
Controller phase loss
MOSFET open circuit error
Controller undervoltage
Controller overvoltage
Battery low temperature
PMU overtemperature High battery
temperature
Motor overtemperature
Controller overtemperature
Software overcurrent
Hardware overcurrent
Speed controller error
Controller pre-charge error
Brake error
Operating sequence error
English
Solution
Communication failure with the right drive controller. Restart
the power supply.
Communication failure with the left blade controller. Restart
the power supply.
Communication failure with the central blade controller. Re-
start the power supply.
Communication failure with the right blade controller. Restart
the power supply.
erly, and then restart the power supply.
Check that the connector under the seat is connected prop-
erly, and then restart the power supply.
Restart the power supply.
Restart the power supply.
Check if the drive wheels are stuck and restart the power
supply.
Restart the power supply.
Restart the power supply.
Check that the Hall-effect connector of drive controller is
properly connected, and then restart the power supply.
Check that motor cables of the drive controller are connec-
ted properly, and then restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
The voltage is too low. Charge the battery pack before use.
The voltage is too high. Restart the power supply.
The temperature of the battery compartment and battery is
too low. Use the machine at a suitable temperature and
restart the power supply.
The temperature of the battery compartment and battery is
too high. Wait for the battery to cool down, and then restart
the power supply.
The motor temperature is too high. Wait for the motor to cool
down, and then restart the power supply.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply.
The load is too high. Restart the power supply.
The load is too high. Restart the power supply.
Check that the speed controller of handle is connected prop-
erly, and then restart the power supply.
Restart the power supply.
Restart the power supply.
Place the left and right handles in the park position, and the
blade start switch in the OFF position. Sit in the seat and try
again.
16