General Power Tool Safety Warnings; Description; Purpose; Overview - Cramer 2502886 Bedienungsanleitung

EN
1 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool.Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
2

DESCRIPTION

2.1

PURPOSE

This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while mowing.
2.2

OVERVIEW

Figure 1-11
Start button
1
Start handle
2
Self-propel drive lever
3
Upper handle
4
Lower handle
5
Grass catcher
6
Rear discharge flap
7
Height adjustment lever
8
Battery compartment flap
9
Mulch plug
10
Side discharge chute
11
Handle hole
12
Handle bolt
13
Handle nut
14
Handle pin
15
Grass catcher handle
16
Grass catcher hook
17
Rear flap rod
18
Side discharge flap
19
Pivot
20
Safety key
21
Battery pack
22
Battery capacity indicator
23
Self-propel speed control
24
Blade bolt
25
Spacer
26
Blade
27
WARNING
English
Battery release button
28
Turbo button
29
3

INSTALLATION

Do not use accessories that are not recommended by the
manufacturer.
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2

INSTALL THE UPPER HANDLE

Figure 2
1. Align the holes in the upper handle and the lower handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.3

UNFOLD THE LOWER HANDLE

Figure 3
1. Pull up on the handle holes to release the lower handles.
2. Fold the lower handle up until the handle pins lock into
position.
4
WARNING
WARNING
WARNING
WARNING
WARNING