Cramer 82ZT107 Bedienungsanleitung Seite 17

Error Code Description
TL20 Angle sensor error
TL21 Relay error
TL22 Magnetic valve error
TL23 Battery compartment (PMU) com-
munication failure
TL24 Battery compartment (PMU) failure
TL25 CAN timeout error - left drive
TL26 CAN timeout error - right drive
TL27 CAN timeout error - left blade
TL28 CAN timeout error - central blade
TL29 CAN timeout error - right blade
TL30 Battery compartment flip cover error Check that the connector under the seat is connected prop-
TL31 Seat switch verification error
TL32 Software authentication error
ML1 Motor positioning error
ML2 Blade motor stalled
ML3 Motor low-speed protection
ML4 Motor overspeed protection
ML5 Motor Hall-sensor error
ML6 Controller phase loss
ML7 MOSFET open circuit error
ML8 Controller undervoltage
ML9 Controller overvoltage
ML10 Battery low temperature
ML11 PMU overtemperature High battery
temperature
ML12 Motor overtemperature
English
Solution
Restart the power supply.
Restart the power supply.
Check that the solenoid valve of drive motor is connected
properly, and then restart the power supply.
Communication failure with battery compartment. Restart
the power supply.
Minor/major error in battery compartment. Perform a check
and restart the power supply.
Communication failure with the left drive controller. Restart
the power supply.
Communication failure with the right drive controller. Restart
the power supply.
Communication failure with the left blade controller. Restart
the power supply.
Communication failure with the central blade controller. Re-
start the power supply.
Communication failure with the right blade controller. Restart
the power supply.
erly, and then restart the power supply.
Check that the connector under the seat is connected prop-
erly, and then restart the power supply.
Restart the power supply.
Restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
Restart the power supply.
Restart the power supply.
Check that the Hall-effect connector of blade controller is
properly connected, and then restart the power supply.
Check that motor cables of the drive controller are connec-
ted properly, and then restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
The voltage is too low. Charge the battery pack before use.
The voltage is too high. Restart the power supply.
The temperature of the battery compartment and battery is
too low. Use the machine at a suitable temperature and
restart the power supply.
The temperature of the battery compartment and battery is
too high. Wait for the battery to cool down, and then restart
the power supply.
The motor temperature is too high. Wait for the motor to cool
down, and then restart the power supply.
17
EN