Tires; Lubrication - Cramer 82ZT107 Bedienungsanleitung

If raising the mower to access the blades, make sure the mower is properly secured and the parking brake is
set before proceeding. Failure to properly secure the mower could cause it to fall, resulting in death or possible
serious personal injury.
3. Wedge a block of wood between the blade and mower deck to prevent the blade from turning.
4. Loosen the blade nut by turning it counterclockwise (as viewed from bottom of mower) using a 16 mm wrench or
socket (not provided).
5. Remove the blade nut, spacer, blade insulator, and blade.
6. Thread the blade nut on the shaft and finger tighten.
7. Torque the blade nut down clockwise using a torque wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is 90 N.m~100N.m (66~74 ft.lbs).
Ensure blade is properly seated and the blade nut is tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose and result in possible serious personal injury.
8. Repeat with second blade, if needed.
Make certain all parts are replaced in the exact order in which they were removed.
7.2

TIRES

It is important for level mowing that all tires have the correct amount of air pressure. The recommended pressure are:
Tire pressure should only be measured or adjusted when tires are cold.
Drive wheels
Front caster wheels
Inspect the tires daily. Replace immediately if damaged.
Check the tire pressure carefully while inflating. Too much air in the tire could cause the tire to burst, causing
serious personal injury.
7.3

LUBRICATION

See figure 19
Please add oil before operation.
Oil type
Oil capacity
Contact your Cramer dealer to replace the lubrication.
Replace the gearbox oil after you operate the machine for 50 hours for the first time, then replace the oil every 200
hours.
English
WARNING
WARNING
NOTE
NOTE
8 psi
37 psi
NOTE
WARNING
SAE85W-140
180 ml
NOTE
21
EN