Transportation And Storage; Transportation - Cramer 82ZT107 Bedienungsanleitung

• Keep battery compartment, deck and operator's station clean of accumulated trash, grass clippings, and other
debris.
• Clean battery compartment, drive motor compartment, mower deck, seat, etc., of all dirt and debris. To clean, use
only compressed air. DO NOT use water, solvents, hard cleaners or abrasives.
• Always wear adequate eye protection when servicing the batteries or when grinding mower blades and removing
accumulated debris. Never attempt to make any adjustments or repairs to the mower's drive system, mower deck
or any attachment while the traction drive system is running. Repairs or maintenance requiring power should be
performed by trained maintenance personnel only.
• Never work under the machine or attachment unless it is safely supported with jack stands. Make certain
machine is secure when it is raised and placed on the jack stands.
• The jack stands should not allow the machine to move when the traction drive system is running and the drive
wheels are rotating. Use only certified jack stands. Use only appropriate jack stands, with a minimum weight
rating of 2000 pounds (907.2 kg) to block the unit up. Use in pairs only. Follow the instructions supplied with the
vehicle stands.
• Do not touch hot parts of machine.
• Keep nuts and bolts tight, especially the blade attachment bolts. Keep equipment in good working condition.
• Never tamper with safety devices. Check their proper operation regularly.
• Turn the key to the "OFF" position before unclogging the discharge chute.
• Never clear the discharge chute with the machine running. Turn the key to the "OFF" position and be sure the
blades have stopped before cleaning. Use a stick to clear a plugged discharge area. Never use your hand!
• Stop unit and allow blades to stop before unclogging chute. Grass collection system components are subject
to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown. Frequently
check components and replace with manufacturer's recommended parts, when necessary.
• Exercise caution when working under the deck as the mower blades are extremely sharp. Wear gloves and use
extra caution when servicing them.
• Use only genuine Cramer Mower parts to ensure that original standards are maintained.
• Always remove batteries when transporting unit. Keep unit free of grass clippings, leaves and other debris.
• Check brake operation frequently. Adjust and service as required.
• Maintain or replace safety and instruction labels, as necessary.
• Have your ride-on lawn mower serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the ride-on lawn mower is maintained.
• Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery
pack may create a risk of fire when used with another battery pack.
8

TRANSPORTATION AND STORAGE

8.1

TRANSPORTATION

Use extra care when loading or unloading the machine into a trailer. Press the low speed drive button and carefully
move the drive levers as needed to control the speed. Always back onto the trailer when loading. When loading or
unloading the mower, do not exceed the maximum recommended operation angle of 15°. Failure to follow these
instructions can result in loss of control and result in death, serious personal injury, or property damage.
Use care when loading or unloading the mower onto a trailer. Ensure the cutting deck is raised to the highest
position so that it is not caught on the ramp. The wheels on the mower can go off the ramp or trailer, causing the
mower to pivot or tip over, and result in a crush hazard that can cause death or serious personal injury.
1. Park the mower on a level surface.
2. Raise the cutting deck to the highest position.
3. Position and secure ramp to the trailer according to manufacturer's instructions.
English
WARNING
WARNING
23
EN