Cramer 82ZT107 Bedienungsanleitung Seite 27

PROBLEM POSSIBLE CAUSE
Battery pack temperature is too high. Do not use it immediately after charging is completed,
The battery power is lower than 5%.
The blade is hit by a foreign object,
causing a sudden stop.
Drive controller is malfunctioning.
The mower cuts The blade is blunt.
the grass un-
Blade is bent.
evenly, and the
height difference
is very large.
Deck is not flat.
The actual mow- Loose fixing bolts of deck.
ing height does
not match the
marked mowing
The deck has been seriously worn or
height chosen.
damaged.
Abnormal vehicle The lawn is too wet.
shredding
The mower is set to cut too much
grass at one time.
Excessive ma- Blades are loose.
chine vibration
Blades are bent.
Uneven deck.
Loose deck.
The mower is set to cut too much
grass at one time.
Grass leaves or The mower is set to cut too much
debris left on the grass at one time.
ground after
mowing.
The grass is too wet.
Driving speed is too fast.
Blade cutting speed is too low.
Short mowing du- Mowing heavy grass may result in
ration short mowing duration.
Mower runaway Different tire pressure
English
SOLUTION
otherwise it may trigger the battery pack temperature
protection error.
The battery pack power is low, please charge the battery.
Turn the start key to OFF position and wait for more than
5 seconds before restarting the machine.
Check the error code apperaring on the display.
Polish the blade according to the manual.
Replace the bending blade, replace the blade in accord-
ance with the instructions, and wear protective gear.
Flatten the deck according to the instructions to ensure
that the left and right heights are equal.
Adjust the fixing bolts of deck to ensure that it is firmly
installed. Note: the deck needs to be re-leveled after
adjusting the mounting bolts.
Replace a new deck.
Before cutting, please check the grass condition. If the
grass is too wet, please wait for the wind to dry or sun-
shine, wait for the lawn dew to dissipate before cutting.
If the grass is too dense and high, please raise the deck
and avoid cutting heavy grass as much as possible.
Polish the blade according to the method in the manual.
Replace the bending blade, pay attention to the correct
replacement of the blade in accordance with the instruc-
tions, and wear protective gloves.
Flatten the deck according to the instructions to ensure
that the left and right heights are equal.
Lock the fixed bolts of the deck.
If the grass is too dense and high, please raise the deck,
try to avoid cutting heavy grass.
If the grass is too dense and high, please raise the deck,
if the grass is higher than 15cm, please use two mowing
cycles to achieve the mowing effect, try to avoid cutting
heavy grass.
Please check the grass condition before mowing, if the
grass is too wet, please wait for the wind to dry or sun-
shine, wait for the lawn dew to dissipate before mowing.
Lower the driving speed.
Increase the speed level of blade.
Raising the deck or decreasing the speed of blade can
increase the mower's usage time on one charge.
Check the rear tire pressure of the mower regularly ac-
cording to the manual.
27
EN