Error Code - Cramer 82ZT107 Bedienungsanleitung

6.1

ERROR CODE

Error Code Description
TR1 Motor positioning error
TR2 Drive motor stalled
TR3 Motor low-speed protection
TR4 Motor overspeed protection
TR5 Motor Hall-sensor error
TR6 Controller phase loss
TR7 MOSFET open circuit error
TR8 Controller undervoltage
TR9 Controller overvoltage
TR10 Battery low temperature
TR11 PMU overtemperature High battery
temperature
TR12 Motor overtemperature
TR13 Controller overtemperature
TR14 Software overcurrent
TR15 Hardware overcurrent
TR16 Speed controller error
TR17 Controller pre-charge error
TR18 Brake error
TR19 Operating sequence error
TR20 Angle sensor error
TR21 Relay error
TR22 Magnetic valve error
TR23 Battery compartment (PMU) com-
munication failure
TR24 Battery compartment (PMU) failure
TR25 CAN timeout error - left drive
English
Solution
Restart the power supply.
Check if the drive wheels are stuck and restart the power
supply.
Restart the power supply.
Restart the power supply.
Check that the Hall-effect connector of drive controller is
properly connected, and then restart the power supply.
Check that motor cables of the drive controller are connec-
ted properly, and then restart the power supply.
If you encounter this issue, contact your distributor for a
solution.
The voltage is too low. Charge the battery pack before use.
The voltage is too high. Restart the power supply.
The temperature of the battery compartment and battery is
too low. Use the machine at a suitable temperature and
restart the power supply.
The temperature of the battery compartment and battery is
too high. Wait for the battery to cool down, and then restart
the power supply.
The motor temperature is too high. Wait for the motor to cool
down, and then restart the power supply.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply.
The load is too high. Restart the power supply.
The load is too high. Restart the power supply.
Check that the speed controller of handle is connected prop-
erly, and then restart the power supply.
Restart the power supply.
Restart the power supply.
Place the left and right handles in the park position, and the
blade start switch in the OFF position. Sit in the seat and try
again.
Restart the power supply.
Restart the power supply.
Check that the solenoid valve of drive motor is connected
properly, and then restart the power supply.
Communication failure with battery compartment. Restart
the power supply.
Minor/major error in battery compartment. Perform a check
and restart the power supply.
Communication failure with the left drive controller. Restart
the power supply.
15
EN