Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
3.3.1 STEERING CONTROL LEVERS
The two levers control the mower's speed, direction, stopping, neutral lock, and parking brake. Levers are used to
steer, accelerate, decelerate, stop, and change direction. When the control levers are in the park brake position, the
mower will not move.
Always drive with both hands. Do not drive with just one hand.
3.3.2 USE THE APP
See figure 9-10
1. Visit the website of Fleet Management: fleet.cramertools.com
2. Create an account and then log in.
3. Invite other users in your organization.
4. Scan the QR code, download the app and log in.
5. Add a device. Find the serial number, pairing code and QR code in the vehicle matching label on this manual.
Scan QR code or type in manually.
3.4
NEUTRAL BYPASS KNOB
See figure 7-8
1. Pull the neutral bypass knobs outwards and then downwards to unlock the wheel.
2. Move the neutral bypass knobs back into position to lock the wheels.
Never drive mower with the neutral bypass knob working. Always install the neutral bypass knob to the original
position before driving! Failure to re-install the knob could cause serious damage to your mower and void mower
warranty!
Never unlock the neutral bypass knob when the machine is working on the slope!
3.5
ANTI-SCALP WHEELS
See figure 2
Anti-scalp wheel kits are standard on Cramer units. These anti-scalp wheels are designed to minimize scalping when
mowing on rough, uneven terrain. After setting the cutting height, adjust the anti-scalp wheels so they extend below
the deck but do not contact the ground. They should always be at least 0.6 cm to 1.9 cm below the deck. With the
unit sitting on a flat level surface, the wheel position can be adjusted up or down as needed from 1.9 cm to 4.4 cm
below the blade surface. Move the wheels up or down - using the different axle mount holes in the wheel mount
bracket (if applicable on model).
4
OPERATING INSTRUCTIONS
4.1
BEFORE OPERATION
4.1.1 ADJUST THE SEAT
See figure 11
Make sure seat pan is securely bolted down prior to each use to prevent seat from moving/tilting in the event of
mower tipping or rollover.
1. Push steer control levers outward into PARK BRAKE position before you adjust the seat.
2. Sit down on seat and lift the seat adjustment lever.
English
NOTE
WARNING
WARNING
WARNING
6
Werbung
Inhaltsverzeichnis
Fehlerbehebung
