KKT KOLBE EB8616TFT Benutzerhandbuch Seite 159

Removing and inserting the catalytic panels
The side catalytic panels are fixed to the cooking chamber
walls by the slide-in rail racks.
To remove them, remove the rail racks from the cooking
chamber together with the catalytic as previously described
and then proceed for each panel as follows:
• First loosen the fixation in the middle of the lower edge of
the panel from the rail grid by pressing it down slightly at
the clamping point (1).
• Then pull the upper hooks of the rail grid out of the holes
of the panel (2).
To reinsert the side catalytic panels, fix them to the rail rack
again in the reverse order to that described above
and reinsert both parts together into the cooking chamber
(see relevant section).
To remove the catalytic fan cover from the cooking chamber
rear wall, proceed as follows:
• Loosen the screws on each side (1) with a screwdriver
while holding the panel.
Note: Put the screws safely aside.
• Then you can carefully lift out the panel.
To refit the fan cover plate to the cooking chamber rear wall,
proceed in reverse order to the above and screw it back in
place with the screws previously loosened.
Cleaning and Maintenance of the Appliance
2
1
2
1
3
71