Automatic Linking Of The Twist To The Rear Of The Wheelchair - Klaxon TWIST Gebrauchsanleitung

12.2 AUTOMATIC LINKING OF THE TWIST TO THE REAR OF THE WHEELCHAIR

The Controller must never be switched on if it is not connected to the wheelchair.
Once the TWIST is installed to the wheelchair, make sure that only the Controller is
activated. Make sure that any other controls are switched off.
It is advisable to avoid using the device when the Controller's battery is running low as, if its
battery runs out, the TWIST will perform a safety stop and can then only be moved by manual
push (no function is active when the Controller is switched off).
Always carry out the linking operation on a flat surface and, if possible, with the wheels of
the wheelchair and the rubbers of the TWIST front kickstand resting on a smooth surface.
It is very important to read the entire sequence described before performing this procedure .
Before performing this procedure, it is very important that the manual procedure explained
in section 12.1 has been carried out correctly at least one time.
Do not perform this operation if there are obstacles of any kind in front of the wheelchair, be
they things, people or animals.
Always perform this procedure with the brakes of the wheelchair engaged.
Perform this operation for the first time only in the presence of a support person. Continue
to perform this operation with a support person until the technique has been mastered.
We recommend performing this procedure only if a rear anti-tip system is installed on the
wheelchair.
Place the TWIST in front of the hook. The upper pin should rest in the opening of the hook located on the
wheelchair (Figure 102).
Make sure there are no obstacles in front of the wheelchair for at least a few metres.
Using the Controller, engage the first gear (see section 9.2). The TWIST will automatically link by moving
upwards. At this point stop the power supply to the TWIST using the stop button on the Controller.
The system is installed and ready for use. To start moving, release the wheelchair brakes and engage the
gear.
Using the device when not properly installed exposes the driver to the risk of losing control
of the vehicle.
60
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 102