Inserting/Removing The Battery - Klaxon TWIST Gebrauchsanleitung

Inserting/removing the battery

Place the TWIST on a flat surface and make sure the device is switched off then:
• to insert the battery, insert it into its housing with the help of the groove on the battery casing (Figure 2)
• to remove the battery, slide it out of its housing while gripping on the groove in the battery (Figure 3)
Switching on the device and the battery
To switch on the TWIST and its battery, ensure that the latter is charged and correctly inserted in its housing,
then press the power button (Figure 2 Letter A) for three seconds until the LED bar lights up. The device will emit
a double acoustic signal (Beep) to confirm that it has been switched on.
Switching off the device and the battery
To switch off the TWIST device and its battery, press and hold down the switch-off button (Figure 3 Letter A) for
three seconds until the LED bar goes off.
Off
14
KLAXON Mobility GmbH - EN
Groove
Battery
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Battery
Groove
On
Figure 2
Figure 3