Klaxon TWIST Gebrauchsanleitung Seite 45

Firmly lift the lever (Figure 63 Letter B) until it reaches the end of its movement and until the Front Hook 2.0
Klaxon® engages, securing the TWIST. Check that linking has been carried out correctly by checking that a
green mark has appeared around the red button (Figure 63 Letter A), this will confirm that linking has been
successfully completed (Figure 63). If the green mark does not appear, repeat the operation from the start.
If the green mark does not appear when the operation is repeated, this means that the Front
Hook 2.0 Klaxon® is not properly engaged. Please contact a KLAXON service centre to carry
out a technical check.
Make sure that the wheels of the wheelchair are not blocked by the brakes. Push the two wheels of the
wheelchair forward at the same time to establish the complete linking of the TWIST to the wheelchair and
to lift up the front castors. (Figure 64)
Once the device has been installed to the wheelchair, it is important to check that the
front castors of the wheelchair are between 25 mm and 40 mm above the ground. If this
requirement is not fulfilled, do not use the device under any circumstances and contact an
authorised KLAXON service centre immediately.
44
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 63
Figure 64