Klaxon TWIST Gebrauchsanleitung Seite 67

Automatic maintenance of a set speed
Once a speed has been set via the Controller, this speed will be automatically maintained both uphill and
downhill.
When driving downhill, the speed can be significantly higher than the set speed, according
to the slope.
Always-on driving safety
Safety is always guaranteed even if the control should disconnect or its battery runs out. In this case, the TWIST
will stop immediately by braking automatically until it reaches 0 km/h.
The motor of the TWIST device does not perform any braking and/or blocking action when
the device is not in motion (recorded speed 0 Km/h). This also refers to the emergency
stop from disconnection when the device comes to a halt (reaches 0 Km/h). It is therefore
necessary to act on the manual wheelchair by actively blocking its movement. It is also
necessary to act on the manual wheelchair to keep it in stationary in position. If the
handlebar is being used, it is also possible to act on the mechanical brake of the TWIST
(provided that the handlebar is properly connected to the device) to block the movement and
keep the wheelchair stationary in position.
Monitoring driving information via smartphone
It is possible to use your smartphone as a dashboard to display driving parameters in real time. By attaching
the smartphone to the wheelchair and activating the KLAXON Web App on the Dashboard page, it is possible
to display the travel speed, the number of kilometres travelled, the battery charge level of the TWIST and of the
connected control, and the remaining range of kilometres in real time.
When using the Web App accessory as a display, the smartphone or any other electronic
device they must absolutely be attached to the wheelchair. Always use the TWIST device only
with both hands free and available for driving.
It is advisable to perform the first driving tests always and only on flat, obstacle-free terrain.
Should the Controller be detached or become temporarily inaccessible to the driver, please
remember that the Assisted Braking function is always available through the blocking of the
wheelchair wheels. Alternatively, it will be sufficient to brake one of the two wheels of the
wheelchair to steer and reduce speed until the motor's thrust is deactivated; this will occur
when the steering angle exceeds 90°.
66
KLAXON Mobility GmbH - EN
KLAXON TWIST device - End User's Manual (EN) - rev. 1.5 of 2023.02.08
Figure 111